About Ship Arch Editor...

Wed Jun 25, 2003 5:20 am by <^>o.0<^>

I haven't found any posts on this, and I have been searching for quite a while now. When I run the program, and when I hit "open", the MS DOS window for bini pops up and it says "Error opening file C:\Program"... Any ideas? I know my paths and directories are right.

Thu Jun 26, 2003 1:21 am by Tapewormlord

Same here man. I get that problem too.........

_____________________________
Dont mistake Santa for Santa Claus!
IXXXXXXX()::::::::::::::::::::::::::>

Thu Jun 26, 2003 11:53 pm by Darklight

The bini.exe must be written in some ancient code as it supports only the old 8.3 character names in ms-dos, so when your Freelancer directory is "program files" you are already doomed, you have to install your freelancer to something like c:\FLancer

On the other side, the author said the new version should work...

Fri Jun 27, 2003 11:06 am by <^>o.0<^>

Well yeah I e-mailed him and now there is the latest version out. Now I have a problem where when I click on the OPEN button, it freezes up. I e-mailed him about and he talks about how I have to make my Data folder to read, write, modify... not just read-only. I set the whole folder to check off read only, but then right when I hit apply, and it says changing attributes, I go back to it, and it's checked back on read-only.

Important Message

You are browsing the archived Lancers Reactor forums. You cannot register or login.
The content may be outdated and links may not be functional.

To get the latest in Freelancer news, mods, modding and downloads, go to
The-Starport